Measurement

When we started, Lynx set out to raise the standard for LGR test results.  We verify the wellsite measurement is accurate prior to the test, resulting in the best test data possible. We utilize the latest technologies in measurement in our units and we are automated to allow immediate data gathering and comparison to ensure test quality, and remote viewing of live conditions.
 

We have a large fleet of mobile LGR test separators.  We have 12"-36" separators available, therefore we can test any well efficiently, new and old.  

We use custom built, high velocity dual-cyclonic separators.  This allows for a very high Liquid-Gas Ratio.   We now routinely test wells with LGR’s approaching 6, and have tested wells up to an LGR of 12.  Some of our test units can be hauled with 3/4 ton pickup trucks, reducing road ban issues. Our largest units can be hauled with 1 ton pickups.

Our equipment is a minimum 600 ANSI rating and sour rated.  
 

All testing and sampling is performed by our experienced technicians, ensuring exceptional results for our customers.  

Our combination of excellent equipment and highly experienced people has resulted in a very low test failure rate.

Lynx provides experienced journeymen and apprentice instrumentation techs on all crews to ensure we perform the best service in the industry.

We can calibrate most types of meters including ultrasonic, mag, vortex, v-cone, coriolis, and water cut meters.  We can complete meter performance verifications and meter health diagnostics.

 Our trained technicians can also obtain your gas, condensate/oil, and water samples under flowing conditions and send off to the lab for analysis.

We have designed our own proprietary digital report to ensure quality calibration results.  With built in error checking and validation, data entry errors are minimized.  Using digital reports makes lost reports a thing of the past.

All crews carry an assortment of orifice plates and seals up to 4", allowing most changes to be made immediately, no extra trip to site.

We provide on-site liquid meter proving, both inline and bench proving to provide maximum efficiency for our customers.  We carry large inventory of parts to ensure we can make repairs as necessary, to minimize any chance of extra trips to site.

We also provide bench proving at our Grande Prairie shop.  If you prefer to remove your meters and bring them in for proving and/or repairs, that works for us too.   

If you bring your turbine meters to the shop for proving, we will swap with one that is ready to go.  No second trip for you.  

Our provers are traceable to Measurement Canada and International Standards.